Device Cleaning Instructions
Smartboard
- Remove dust, dirt and grease by swiping the writing surface with a damp cloth or swamp. Use mild soap when needed.
- Do not spray a cleaning solution directly on the interactive surface. Instead, spray a small amount of the solution on a cloth with which to swipe the interactive surface.
- Do not let the excess solution run onto the reflecting surfaces of the frame.
- Do not touch the digital cameras mounted to the upper corners of the frame. Do not try to clean out the digital cameras unless specifically instructed to do so by SMART Technologies.
- If ink gets by mistake onto the surface of the interactive board, remove the ink as quickly as possible. The longer ink stays on the surface the more difficult it is to clean it off.
- Do not apply strong chemicals or abrasive cleaners to the interactive surface.
- Before you clean the interactive board, unplug the USB cable.
- You can see dirt and stripes better if you set the projector to standby mode (lamp turned off).
Touchscreen
- Unplug power from the screen, the computer, and accessories.
- Swipe off dust from the screen using a soft and slightly damp lint-free cloth.
- Avoid getting moisture in any openings.
- Do not clean iPad using window cleaning solutions, house cleaning products, aerosol spray, solvents, alcohol, ammonia, or abrasives.
- You can swipe off fingerprints from the screen using a soft lint-free cloth.
Touchscreen phones (iPhone, Lumia, Samsung, etc.)
- Unplug all cables and turn off the phone.
- Use a soft, slightly damp lint-free cloth.
- Avoid getting moisture in any openings.
- Do not clean iPad using window cleaning solutions, house cleaning products, aerosol spray, solvents, alcohol, ammonia, or abrasives.
- You can swipe off fingerprints from the screen using a soft lint-free cloth.
MacBook (surfaces)
- Power off the computer and unplug the power module.
- Swipe clean the outer surfaces using a soft and damp lint-free cloth.
- Avoid getting moisture in any openings.
- Do not spay liquids directly onto the computer.
- Do not use aerosol spray, solvents, or abrasives which may damage the surface.
MacBook (display)
- Power off the computer and unplug the power module.
- Dampen the provided cleaning cloth with plain water and swipe the display.
- Do not spray liquids onto the display.
On MacBook bottom (13 inch, end of 2009, mid 2010) there is soft nons lipping material. Use 3M grey microfiber cloth or soft, colorfast lint-free cloth to clean out the bottom.
Laptops (cooling)
- A common cause for overheating in laptops is accumulation of dust inside the computer. Dust can block air passages resulting in the fan running on high speed all the time.
- Air passages can be cleared using a compressed air can. Compressed air must be blown in all air passages to make air flow and to keep dust settling on components.
- Created by Kalevi Lehto on 5.11.2013
You are viewing an old version of this page. View the current version.
Compare with Current View Page History
Version 1 Next »
- No labels